This page provides information about the specific mandatory steps required to run a Power Builder analysis.

For Power Builder 11.5 and more recent : Install Power Builder

If you are analyzing an older version of Power Builder, then you do not need to install the product. A folder containing the Shared DLLs on the analysis machine is enough.

If you are analyzing Power Builder 11.5 or more recent, then you will need a licence, so you need to install it on the analysis machine.

Add the Shared DLL folder to the PATH environment variable

This step is necessary whatever the version of Cast-AIP and the version of Power Builder.

If Power Builder is installed, then this folder is : <INSTALL_FOLDER>\srvsources\qualityassurance\STD\pb\Parsing\Shared_PB<version number> 

If not, it is where you put the Shared DLLs.

If you forget this step, you will encounter the following error message :

 Cannot load <full path to pborc<version>.dll>, the specified module could not be found.  

Enlighten - Code viewer - Power Builder - Error - Cannot load XXXX PowerBuilder PBORC125 DLL The specified module could not be found

CMS Snapshot Analysis - Run Analyzer - Fatal Error - Power Builder with Core CAST AIP - Cannot load XXX PowerBuilder pborc version dll - The specified module could not be found