Introduction

The final step is to generate your Snapshot, which enables you to create data that can be exploited primarily in the Health and Engineering Dashboards.

Generate the snapshot

To generate a snapshot, move to the AIP Console screen if you are not already there:

Locate the Application and click the Take a snapshot option as highlighted below:

In the subsequent popup, before clicking Proceed, ensure:

The snapshot process will then start - the Progress window will indicate that the snapshot is in progress:

See Application - Overview for more information about the Generate snapshot indicators step.

The snapshot is complete when the Progress window indicates a successful completion:

Validate snapshot

Validate using the Engineering Dashboard

The easiest and quickest way to check the results of a snapshot generation is to open the Engineering Dashboard and view your results. If you are using embedded Dashboards, you can click the Engineering Dashboard icon (no login required):

Validate using the snapshot report

Every time a snapshot is generated for a given Application, a report is created in JSON format summarizing the content and other information. This report can help validate your snapshot to ensure that it is coherent. You can find the report in the following location on the AIP Node that was responsible for running the snapshot:

%PROGRAMDATA%\CAST\AipConsole\AipNode\snapshot-report\<application-name>\<application-guid>.<version-guid>.snapshot_YYYYMMDDHHmm.report.json

Delete snapshot if not satisfactory and then regenerate

If the initial snapshot is not satisfactory, delete it - this will delete it from the Dashboard schema. To do so, locate the Application and click it:

Click to enlarge

Locate the Application and click it to access the Application - Overview page:

Locate the snapshot and then delete it:

Once deleted, you will need to perform any configuration changes that might be necessary and then generate the snapshot again (no need to run the analysis or upload to Measurement schema):

You can also use the icon in the Snapshot Management screen:

Upload snapshot to Measurement schema

If the snapshot now contains the information you expect, then you can upload it to the Measurement Service:

Note that the Health Dashboard can officially support the upload of a maximum of 200 applications. CAST recommends that you choose only the most critical applications from the business view point - i.e the applications that need to be monitored with high visibility by CIOs and managers.

Manual upload

You can perform a manual upload of the snapshot you have just generated to the Measurement schema for display in the Health Dashboard:

Click to enlarge

Check results in the Health Dashboard

Open the Health Dashboard and view your results. If you are using embedded Dashboards, you can click the Health Dashboard icon (no login required):