Introduction
In an Advanced rescan scenario, you now have two choices depending on the source code that you delivered in the new version of your Application:
- If the new Version contains only updated source code and no new technologies, and/or you made no significant changes to the analysis configuration settings, you can proceed with a snapshot and an analysis, together with an upload of the data into the Measurement schema for use with the Health Dashboard.
- If the new Version contains new technologies, and/or you made changes to the analysis configuration settings, it is more prudent to run an analysis and validate these results before you generate a snapshot and upload the data into the Measurement schema.
Run analysis and/or generate a snapshot
To run an analysis or generate a snapshot, move to the AIP Console screen if you are not already there:
Locate the Application and click the Run analysis option as highlighted below:
In the subsequent popup, before clicking Run ensure you have chosen the correct options depending on your situation as outlined in the Introduction section above:
| Analysis only | Analysis/snapshot/upload to Measurement |
|---|---|
|
|
At this point the analysis and/or snapshot process will start:
| Analysis only | Analysis/snapshot/upload to Measurement |
|---|---|
|
|
On completion if you need to validate either the analysis or snapshot, please see the following sections from the Advanced onboarding section:
If you ran only an analysis, you will now need to generate a snapshot and upload the results to the Health Dashboard:
