CMS Snapshot Analysis - Compute Analysis Unit Full Content - Number of objects selected 0 - Power Builder
Description
When you are performing power builder analysis you are getting below warnings in the analysis log and 0 objects selected in the CAST-MS GUI as shown in the attached screen shots.
*
*Figure 1
*
*Figure 2
Observed in CAST AIP
| Release | Yes/No |
|---|---|
| 8.3.x | ✅ |
| 8.2.x | ✅ |
| 8.1.x | ✅ |
| 8.0.x | ✅ |
| 7.3.x | ✅ |
| 7.2.x | ✅ |
| 7.0.x | ✅ |
Observed on RDBMS
| RDBMS | Yes/No |
|---|---|
| Oracle Server | ✅ |
| Microsoft SQL Server | ✅ |
| CSS3 | ✅ |
| CSS2 | ✅ |
| CSS1 | ✅ |
Step by Step Scenario
- Configure and run the analysis
- Number of objects selected 0 seen in the CAST-MS for Power builder job.
Action Plan
This issue is because of the configuration when there is a mismatch of power builder version at technology level and Analysis unit level.
- Ensure that Power builder version at technology level is same as the Analysis unit level, refer the attached.screen shots.
Figure 3
Figure 4
Impact on Analysis Results and Dashboard
Impact of issue: Analysis shows warnings in the analysis log and number of selected objects would be 0 in CAST-MS.
Impact after applying solution: Analysis runs fine with number of selected objects.
Notes/comments
Ticket # 4272
Related Pages