Description
When you are performing power builder analysis you are getting below warnings in the analysis log and 0 objects selected in the CAST-MS GUI as shown in the attached screen shots.
Figure 1
Figure 2
Observed in CAST AIP
Release | Yes/No |
---|---|
8.3.x | |
8.2.x | |
8.1.x | |
8.0.x | |
7.3.x | |
7.2.x | |
7.0.x |
Observed on RDBMS
RDBMS | Yes/No |
---|---|
Oracle Server | |
Microsoft SQL Server | |
CSS3 | |
CSS2 | |
CSS1 |
Step by Step Scenario
- Configure and run the analysis
- Number of objects selected 0 seen in the CAST-MS for Power builder job.
Action Plan
This issue is because of the configuration when there is a mismatch of power builder version at technology level and Analysis unit level.
- Ensure that Power builder version at technology level is same as the Analysis unit level, refer the attached.screen shots.
Figure 3
Figure 4
Impact on Analysis Results and Dashboard
Impact of issue: Analysis shows warnings in the analysis log and number of selected objects would be 0 in CAST-MS.
Impact after applying solution: Analysis runs fine with number of selected objects.
Notes/comments
Ticket # 4272
Related Pages