CAST Imaging System - Source code - Source code for this object is not available

This page handle the case when you get the following message while viewing the source code of an object : Source code for this object is not available

1. View objects source code

1. Check if the source code viewer was configured properly - Configure the source code viewer
2. Check if the source code of the object is stored on the knowledge schema - SQL Queries - CAST Knowledge Base - Queries on source code - How to get the source code for a given object id
   1. If the object source code is not stored in the knowledge schema then perform the following from CMS - CMS - Upload Source Code for viewing in CAST Dashboard. If the issue still persists after that then contact  CAST Technical Support. with the following Relevant Input
   2. Else if the object source code is stored in the knowledge schema then export the application in debug mode - CAST Imaging System - Information - Export application in debug mode then contact  CAST Technical Support. with the following Relevant Input

3. If source code is not visible for VB technology then refer  CAST Imaging System - Source code - Source code for this object is not available - For Visual Basic objects . This is applicable only for  CAST AIP  versions till 8.3.13.

4. If the problem you are facing does not match any case listed in this page, report your problem to CAST Technical Support and provide the following Relevant Input